Table of Contents
Advertisement
Commissioning
6.1 Switching on the monitor
6 Commissioning
The following sections describe how to make the settings for optimum operation of the sys-
tem, comprising the monitor and video source.
The video source for example can be a PC with graphics card, or a diagnostic imaging de-
vice.
6.1 Switching on the monitor
To switch on the monitor, proceed as follows:
•
Switch on the monitor using the power switch.
Note: The power switch is located on the back of the monitor, next to the connection
panel.
•
Wait until the operation LED in the front panel of the monitor turns green.
6.2 Using a screen saver
Image sticking may occur with LCD monitors. Image sticking is an effect whereby a faint im-
age of the previous screen contents can be seen after the display contents have changed.
This occurs in particular when the same image content is displayed over an extended period
of time.
You can prevent image sticking by using a screen saver with image content that changes
regularly.
6.3 Selecting the LUT
Five LUTs (Look Up Tables) are predefined on the monitor. The requested LUT can be set
with the function "LUT" in the OSD menu "image" or by quick link with the OSD menu closed
by using the OSD button 1.
6.4 Adapting the monitor to an analog video source
Note
• To achieve optimum picture quality, the monitor must be operated with a graphics reso-
lution of 1280 x 1024 pixels. A corresponding setting for the graphics card of the video
source must be made.
• To set the monitor optimally, allow it to warm up at least 30 minutes.
This section describes how to adapt the monitor to operate with an analog video source.
The procedure is divided into the following steps:
•
Adjust the position, phase and frequency.
•
Adapt brightness and contrast.
20
CuratOR LX1910
Instructions for Use, 08/2022
Advertisement
Table of Contents
