Troubleshooting; Fault Correction - Eizo CuratOR LX1910 Instructions For Use Manual

Troubleshooting

9.1 Fault correction

9 Troubleshooting
9.1 Fault correction
Fault
Operation LED dark
No picture is displayed
Operation LED green
A picture is displayed
Operation LED flashes green
No picture is displayed
Operation LED lights up orange
No picture is displayed
Operating LED lights up orange
A picture is displayed
Operating LED flashes orange
A picture is displayed
Picture is without contrast and
has a strong green shading
Miscellaneous
36
Cause
Blown fuse
Power cable not connected or
connected incorrectly
The applied video signal was
recognized. No error.
The monitor scans for a suitable
video signal:
• No sync signal or video sig-
nal
• The video source is not
sending a video signal, or is
sending an unknown timing.
• The video source is sending
an unknown timing
The monitor or video source is
in energy saving mode.
Overtemperature: The tempera-
ture threshold exceeded 42 °C.
Overtemperature: The tempera-
ture threshold exceeded 47 °C.
Brightness is reduced.
Brightness returns to the regular
value as soon as the tempera-
ture falls sufficiently.
The video source is only trans-
mitting a green signal
Loose plug
Defective cable
Remedy
• Contact service.
• Check the power cable.
• Is the power switch in the
"On" position?
Measures:
• Check the video cable.
• Check the video source.
• Set a different timing for the
video source.
• Exit the energy saving
mode(s)
• If no picture is still displayed
and the operation LED is
flashing green, perform the
measures listed there.
Check the following:
• Is the ambient temperature
in the acceptable tempera-
ture range?
• Are the housing cooling fins
free and open?
• Was the required distance
between the monitor and
other objects maintained
during installation?
• Is there a heat source near
the monitor?
• Switch to "Monochrome (G)"
in the OSD menu.
• Connect the loose plug and
secure it.
• Replace the defective cable.
CuratOR LX1910
Instructions for Use, 08/2022