Commissioning; Switching On The Monitor And Video Source - Eizo CuratOR LX3240-MR Instructions For Use Manual

6 Commissioning

Note
Factory settings
All monitors are optimally preset in the factory, such that changes are not usually required.

6.1 Switching on the monitor and video source

Note
To obtain the best possible results, the video source should support communication via the
Auxiliary (AUX) Channel of the DisplayPort.
The monitor and video source can be switched on in any order.
Switching on the monitor before the video source
ü The video source and power supply are connected correctly.
1. Switch on the monitor.
ð The operation LED lights up yellow.
2. Switch on the video source.
ð If the connected signal can be displayed on the monitor, the operation LED will light
green.
Switching on the video source before the monitor
ü The video source and power supply are connected correctly.
1. Switch on the video source.
2. Switch on the monitor.
ð If the connected signal can be displayed on the monitor, the operation LED will light
green.
CAUTION
Operation LED does not light green?
If the operation LED does not light green after the equipment has been switched on and a
video signal has been applied:
• check the system for basic connection and operating errors before contacting service
personnel.
CuratOR LX3240-MR
Instructions for Use, 06/2022
6.1 Switching on the monitor and video source
Commissioning
25