Table of Contents
Advertisement
Chapter 1 Getting Started
12
Reset Button
To shut down and reboot the TeraStation, press and hold this button.
13
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
14
Fan
Spins to prevent overheating inside. Do not block the fan.
15
VGA Port
You can connect a VGA monitor to this port. Connecting a monitor directly to the TeraStation is only supported
for monitoring the progress of Windows Update.
16
USB Port
Compatible Buffalo USB drives, USB memory devices, and USB UPS connections can be connected. USB hubs
are not compatible.
17
LAN Port 1 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
18
LAN Port 2 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
19
LAN Port 3 (10GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 10 Gbps
if using the included Ethernet or category 6A cable.
20
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
21
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
22
Serial Number
This sticker shows the TeraStation's serial number.
23
UID Button
Press the UID button on the front or the back of the unit to cycle the blue LED on and off.
24
Link/Act LED
Glows green when the TeraStation is connected to a network. It blinks when the connection is active.
25
Link/Act LED
Glows amber when the TeraStation is connected to a network at 100 Mbps. It blinks when the connection is
active.
26
Link/Act LED
Glows green when the TeraStation is connected to a network at 1000 Mbps, 2.5 Gbps, or 5 Gbps. It blinks when
the connection is active.
27
Link/Act LED
Glows blue when the TeraStation is connected to a network at 10 Gbps. It blinks when the connection is active.
9
Advertisement
Table of Contents
