Table of Contents
Advertisement
2.6 Buttons
2.6.1
The resettable fuse (H) is used to reset the V Series in case the fuse tripped. This is a single push button to the
bottom left of the Ethernet RJ-45 jack. Also, there is a reset switch for hardware and another for software.
2.6.2
Hardware Reset (I): The Hardware Reset button performs a hard reboot of the processor. This hard reboot will
immediately switch controlled outlets off, removing power to connected equipment on all outputs.
2.6.3
Software Reset (J): The Software Reset button is a multi-functional control depending on length of press. If the
button is held for longer than 10 seconds, the unit resets itself to factory defaults, and all custom configurations
are erased. If the button is held for less than 10 seconds, the unit will perform a software reset that will not reset
any data, or power cycle the connected equipment.
3.
Rack Installation
V Series is designed to be installed vertically in the back of an equipment rack. The supplied nuts, bolts and washers
must be used to mount the V Series to the rack through the mounting holes (A) following the appropriate local regulations
and requirements.
1. PDU (Quantity 1)
2. Mounting Brackets (Quantity 2)
3. 8-32 Mounting Bracket Screws (Quantity 8)
4. 10-32 Rackscrew Truss-Head - 4 Pieces (Quantity 4 pairs)
© 2023 AMETEK SurgeX | Technical Support 800-645-9721 | surgex.com
User Manual
8
Advertisement
Table of Contents
