Table of Contents
Advertisement
2.4
USB OTG
The USB-micro AB connector is for OOB diagnostics and troubleshooting IP connectivity issues. To use, please
use the discovery tool at ametekesp.com or manually enter the static IP address 169.254.10.100 into a supported
browser. The web server will always be accessible at 169.254.10.100 through this USB port. The web server on
this interface cannot be changed, and will always be unsecured HTTP at port 80.
3.
LED Indicators
Squid has a total of nine LED Indicators:
•
[4] AC Outlet. When illuminated, the corresponding AC outlet is on
•
[2] DC Output. When illuminated, the corresponding DC output is on
•
[2] Ethernet Connection and Activity
•
[1] Surge Protection OK (on opposite side of pictured view)
4.
Buttons
There are two recessed pushbuttons located to the right of the Ethernet RJ-45 jack. The Hardware Reset button is furthest
from the RJ-45 jack, and the Software Reset button is closest.
4.1
Hardware Reset
The Hardware Reset button performs a hard reboot of the processor. This hard reboot will immediately switch
controlled outlets off, removing power to connected equipment on all outputs except the 5V output.
4.2
Software Reset
The Software Reset button is a multi-functional control depending on length of press. If the button is help for greater
than 10 seconds, the unit resets itself to factory defaults, and all custom configurations are erased. If the button is
held for less than 10 seconds, the unit will perform a software reset that will not reset any data, or power cycle the
connected equipment.
© 2021 AMETEK Power Quality Solutions | Technical Support 800-645-9721 | surgex.com
User Manual
6
- Quick Links:
- Login
Hide quick links:
Advertisement
Table of Contents
