Device Setup - Ametek SurgeX Vertical+ Series User Manual

4.4.1 Device Setup

The Device Setup page allows for the specification of basic device parameters.
4.4.1.1 Device Configuration
The Device Configuration tab allows for the specification of visual feedback and device initialization.
Item
Device Name
Nominal Voltage
Nominal Frequency
Power-Up Delay Time
On Power Up
On Shutdown Clear
Temperature Display
Auto Logout
Auto Ping Frequency
Auto Ping Timeout
© 2023 AMETEK SurgeX | Technical Support 800-645-9721 | surgex.com
Device Configuration
Description
Specifies the name label to be associated with this Vertical Series Plus device.
Specifies the expected voltage on the input receptacle. This selection does NOT change any
settings for over/under voltage shutoff. This is only for visual coloring on gauges.
Specifies the expected frequency on the input receptacle. This selection does NOT change any
settings for triggers. This is only for visual coloring on gauges.
Specifies the amount of time in seconds by which to stagger the manual turning on of multiple
outlets when applying the initial state.
Specifies whether to set outlets to initial states run a predefined sequence when Vertical Series
Plus device powers up, or the hard reset button is pushed.
Specifies whether to set outlets to initial states run a predefined sequence when Shutdown state
clear.
Specifies whether to display temperature in degree Fahrenheit or Celsius.
Specifies the web security timeout in minutes.
Specifies how frequent the Vertical Series Plus device will send pings to an IP Address or
Hostname in an auto ping trigger.
Specifies the amount of time the Vertical Series Plus device will wait for a ping response before
calling the attempt a failure.
User Manual
14