Network Advanced Setup - Ametek SurgeX Vertical+ Series User Manual

4.4.3 Network Advanced Setup

The Network Advanced Setup page allows for the specification of more advanced network security and
monitoring options.
4.4.3.1 SNMP
Item Description
Enable SNMP Specifies whether to enable the SNMP agent.
Port Specifies the port number for the SNMP agent. 161 is the standard SNMP port.
SNMP V1 Communities Is a table of all SNMP communities, supporting SNMP V1 at a minimum.
Name Specifies the Community name for read and/or write access.
Source Specifies an unrequired whitelist. If requests are not to be filtered by hostname or IP Address, this field can
be left blank.
Access Specifies the type of access allowed by the community.
SNMP V3 users Is a table of Users specifically for SNMP V3 authorization. Users here will not apply to the REST API, and
REST API users will not be able to authenticate via SNMP V3 without redefining their credentials here. SNMP
credentials cannot be authenticated using the LDAP Client.
Name The name or username for authorization.
Authorization Type of encryption used per user. Options are DES or MD5.
Access Type of access per user. Options are Read Only or Read/Write.
Passphrase Passphrase or password for the user.
Trap Receivers Is a table of all the destinations for SNMP traps.
Name The name of the community for traps.
Host Name The hostname or IP address of the SNMP Manager that is going to receive traps.
Port The port number that the SNMP Manager is listening for traps on.
Traps Sent Specifies which specific traps are to be sent. Triggers send traps for Triggering and Clearing. Manual Control
sends traps for outlet state changes, and Authentication sends traps for failed authentication attempts.
© 2023 AMETEK SurgeX | Technical Support 800-645-9721 | surgex.com
The SNMP tab allows for the specification of parameters for the SNMP agent, supporting V1
through V3.
SNMP Setup
User Manual
19