Users Setup; Sequences Setup - Ametek SurgeX Vertical+ Series User Manual

4.4.5

Users Setup

The Users Setup page allows for the creation,
deletion, and editing of user accounts. Each user
will have a unique name, username,
authentication mode, and may be assigned
access to specific features.
LDAP and Internal authentication modes are
supported.
The following privileges may be assigned or
revoked as necessary:
•
•
•
•
•
4.4.6

Sequences Setup

The Sequences Setup page allows for the
creation and modification of sequences. A
sequence is a set of actions to be taken in
a specific order, and with a specified
delay time between each step. Using
sequences avoids manually performing
each action, or turning each outlet on or off,
individually.
A sequence, as defined for this product, is purely a one-way sequence. That is, you do not use the same
sequence to turn outlets on as you use to turn the same outlets off in reverse order. One sequence must be
created for the turn-on function, and then a second sequence must be created for the turn-off function.
To create a new sequence, press the "Add Sequence" button. The new sequence must be given a unique
name. This name should clearly indicate what the sequence will do, such as "All On", "All Off" or "Stage
Equipment On".
To run a sequence to test it, press "Run Sequence". To edit an existing sequence, press the pencil icon. To delete
a sequence, press the minus "-" icon.
© 2023 AMETEK SurgeX | Technical Support 800-645-9721 | surgex.com
Trigger Config
Device Control
Network Settings
Software Update
User Administration
User Manual
26