Device Setup - Ametek SurgeX Squid SX-DC-8-12-120 User Manual

5.4.1

Device Setup

The Device Setup page allows for the specification of basic device parameters.
5.4.1.1
Device Configuration
Item
Device Name
Nominal Voltage
Nominal Frequency
Power Up Delay
Time
On Power Up
On Shutdown Clear
Temperature Display
Auto Logout
Auto Ping Frequency
Auto Ping Timeout
© 2021 AMETEK Power Quality Solutions | Technical Support 800-645-9721 | surgex.com
Device Configuration
The Device Configuration tab allows for the specification of visual feedback, and
device initialization.
Description
Specifies the name label to be associated with this Squid.
Specifies the expected voltage on the input receptacle. This selection does NOT change any
settings for over/under voltage shutoff. This is only for visual coloring on gauges.
Specifies the expected frequency on the input receptacle. This selection does NOT change any
settings for triggers. This is only for visual coloring on gauges.
Specifies the amount of time in seconds by which to stagger the manual turning on of multiple
outlets when applying the initial state.
Specify whether to set outlets to Initial States or run a predefined Sequence when Squid powers
up, or the Hard Reset button is pushed.
Specify whether to set outlets to Initial States or run a predefined Sequence when a Shutdown
State clears.
Specifies whether to display temperature in degrees Fahrenheit or Celsius.
Specifies the web security timeout in minutes.
Specifies how frequent the Squid will send pings to an IP Address or Hostname in an autoping
trigger.
Specifies the amount of time the Squid will wait for a ping response before calling the attempt a
failure.
User Manual
10