Zepro Z 1500 Technical Manual page 17

Control cards
2.1.8 Display and LED's
The control card is equipped with two LED's and an alphanumeric display with a status point on the lower right
corner which provide useful information about the system.
• The status dot has three states:
• Off: no supply voltage to control card.
• On: supply voltage is available but the cabin switch is switched off.
• Flashing: supply voltage is available and the cabin switch is switched on. The card is awaiting input signal.
When a button press is being registered by the card, LED1 is lit and when the signal from the control device and
sensors is registered and approved by the card, LED2 is lit to indicate an active output.
Startup sequence
Every time the card is switched on, either by turning the cabin switch off and then back on or by cutting the
power to the lift and turning it back on, a startup sequence is displayed on the display. The software configu-
ration is displayed first, followed by the detected voltage and the firmware version number. It is crucial that
the software configuration is the correct one for the tail lift it is installed on, see the software configurations
chapter for more information.
www.zepro.com 17