Front Panel; S/Pdif - DFI CS632 User Manual

Internal I/O Connectors
X

Front Panel

„ Front Panel Pin Assignment
Pin Assignment
1 N.C.
3 HDD Power
HD-LED
5 Signal
7 Ground
RESET
9 Signal
11 N.C.
HDD-LED - Hard Disk Drive LED
Lighting of the LED indicates that the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light up. When the system is in the S1 (POS -
Power On Suspend) state, it will blink at 1-second intervals. When the system is in the S3 (STR
- Suspend To RAM) state, it will blink at 4-second intervals.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
User's Manual | CS632
1 2
PWR-LED
HD-LED
ATX-SW
RESET
11 12
„ Front Panel Connector
Pin Assignment
2 LED Power
PWR-LED 4 LED Power
6 Signal
8 Ground
ATX-SW
10 Signal
12 ---
Internal I/O Connectors
X

S/PDIF

„ S/PDIF Connector
1
The Sony/Philips Digital Interface (S/PDIF) connector is for audio output to external audio
equipment. The S/PDIF port may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then connect the audio cable to
the S/PDIF connector. Make sure pin 1 of the audio cable is aligned with pin 1 of the S/PDIF
connector.
„ S/PDIF Pin Assignment
Pin
1
2
3
4
5
Chapter 2
HARDWARE INSTALLATION
Assignment
+5V
---
SPDIF Out
GND
SPDIF In
27