DFI CS632 User Manual page 13

CPU Installing the CPU
X X
5. Lift the load lever and the load
plate all the way up as shown in
the photo.
6. Remove the protective cap from
the CPU socket. The cap is
used to protect the CPU socket
against dust and harmful par-
ticles. Remove the protective
cap only when you are about to
install the CPU.
7-1.Insert the CPU into the
socket. The gold tri-
angular mark on the
CPU must align with
the chamfer corner of
the CPU socket shown
in the photo.
Important:
The CPU will fit in only one orientation and can easily be seated without exerting
any force.
User's Manual | CS632
Load lever
Load
plate
Protective cap
Golden triangular
mark
CPU Installing the CPU
X X
7-2. Two keys on the sock-
et and notches on the Alignment key
CPU also facilitate
alignment.
Alignment key
7-3.The CPU's notch will
fit into the socket's
alignment key when it's
seated in the correct
orientation.
8. Close the load plate
then push the load le-
ver down.
While closing the load
plate, make sure the
front edge of the load
plate slides under the
retention knob.
9. Press down the load
lever and hook it under
the retention tab.
Chapter 2
HARDWARE INSTALLATION
Load lever
Retention knob
12