Accessing Telnet; Configuring Snmp Functions - Net to Net Technologies SIA2410R User Manual

Accessing Telnet

You can use a console cable for serial communication between the Net To Net
Technologies SIA2410R unit and the user's PC in order to configure the router.
Also, network-connected users can configure the router by means of the
Telnet application provided from the user's PC through the network.
Once the SIA2410R unit has been configured with an IP address, you can use
the IP address to open a Telnet session with the unit from any computer on
the same Ethernet network. If the unit is connected to just one computer, the
Ethernet network comprises the computer and the SIA2410R unit.
The SIA2410R supports both telnet client and telnet server. Your computer
can connect to the SIA2410R unit and the SIA2410R unit can connect to the
workstation or router on the same Ethernet network.

Configuring SNMP Functions

Accessing a SIA2410R with the factory default configuration
1> Use a 10BASE-T straight-through cable to connect the NIC
card in the user's PC with the "LAN" port of the SIA2410R
router.
2> Configure the IP address of the router to 192.168.1.1/24. If
you use the Bridging-only mode, you must type the following
command : (conf)# ip routing disable lan
3> Change the IP address of the user's PC to 192.168.1.2, and
the subnet mask to 255.255.255.0.
4> Run MS-DOS after the user's PC is done with rebooting
(Windows95/98).
5> Enter "ping 192.168.1.1" in the MS-DOS prompt field.
6> If there is a response, enter "telnet 192.168.1.1" in the
prompt field. If no response, check if the cable is in place.
Note: Commands used for Telnet access are the same for console access.
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
52