User Mode - Net to Net Technologies SIA2410R User Manual

User Mode

The Net To Net Technologies SIA2410R supports two modes: Login Mode and
Configuration Mode. The two modes allow operators to monitor the router
without giving them access to configuration commands.
Login Mode
The Login mode only allows the user to monitor the router functions; it
does not allow configuration commands.
Activating the Login Mode:
1. Enter the password and press Enter. The default password is
'password':
Password : password
If you enter the correct password, the command-line prompt appears
as follows :
SIA2410R>
2. To close this mode, enter 'exit' at the command prompt:
SIA2410R> exit
Note: The default password must be typed in lower case. If the properly
typed default password does not work, check whether 'Caps Lock' is on
or not.
Configuration Mode
The Configuration mode allows all commands to be entered by the user.
To Activate the Configuration mode, type in the following command whilst in
Login mode:
1. SIA2410R> enable
2. Enter the password and press Enter. The default password is
'password':
Password: password
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
14