Net to Net Technologies SIA2410R User Manual page 18

To display the LAN interface configuration, use the following command:
Command show interface [-v|-c] [<ifname>]
-v
Parameters -c
<ifname>
(conf)# show interface lan
Interface: lan, status <UP>, mtu 1500
ip address 168.126.188.130 255.255.255.0
Routing-only mode
ether 00:d0:84:01:08:b2, speed 100 Mbps full-duplex
(conf)#
(conf)# show interface -v lan
----------------------------------------------------------------
Interface: lan, status <UP>, mtu 1500
----------------------------------------------------------------
ip address 168.126.188.130 255.255.255.0
Usage Examples
Routing-only mode
ether 00:d0:84:01:08:b2, speed 100 Mbps full-duplex
descriptor rhead:0x921e0 thead:0x91db8 ttail:0x91db8
statistics:
(conf)#
(conf)# show interface –c lan
Note: To display all interfaces, use the "show interface" command.
Deleting the secondary IP address
Command int <ifname> delete [secondary] <address>
<ifname>
Parameters [secondary]
<address>
Usage (conf)# int lan delete secondary 172.16.10.1
Examples
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
shows full statistics
initializes the statistics
interface name
10 RxOK, 0 RxNoBufs, 0 RxMiss
0 RxCRCErr, 0 RxAlignErr, 0 RxDribbles
5 TxOK, 0 TxNotReady, 0 TxTooBig
0 TxLossCRS, 0 TxLateCols, 0 TxCollisions
interface name
indicates a secondary IP address
IP address
17