Connecting Cables - Net to Net Technologies SIA2410R User Manual

Connecting cables

This section explains the physical set up for the Net To Net Technologies
SIA2410R router.
Connecting Power Cables
1. Plug the AC/DC adapter into the mains outlet.
2. Plug the other end of the AC/DC power adapter into the port named
"DC5V" in the back of the SIA2410R unit.
3. Switch the power switch to the ON position.
4. Confirm if the LED named "POWER" is illuminated on the front panel.
Note: If the LED is not on, check that the power cable is properly connected
or that the AC supply is switched on.
Connecting LAN Port
1. Connect one end of the UTP cable to the network equipment such as a
PC, switch or other network device.
2. Connect the other end of the UTP cable to one of the "LAN" ports on
the back of the SIA2410R unit.
3. Confirm if the LED named "LINK" is illuminated for the appropriate LAN
port.
Note1: If the LED is not on, check if the UTP cable is properly connected or if
there is a break in the cable.
Note2: You can use both a UTP Straight-through cable and a UTP Cross-over
cable to connect the PC or network device to the SIA2410R's LAN port,
the port automatically adapts if a crossover connection is required.
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
10