Viewing The Routing Table - Net to Net Technologies SIA2410R User Manual

Deleting the static route :
(conf)# ip route del default|all
Command
(conf)# ip route del <net> <mask> [<ifname>] [<gw>]
default
all
<net> <mask>
[<ifname>]
Parameters
<gw>
(conf)# ip route del all
Usage
(conf)# ip route del 210.10.10.0 255.255.255.0
examples
(conf)# ip route del default

Viewing the Routing Table

To display information for the routing table, use the following
command.
Command show ip route [-a]
Parameters -a
(conf)# show ip route
destination
Usage
---------------------------------------------------------------------
Examples
default
210.10.11.0
168.126.188.0
Note: The SIA2410R dynamically adds a directly connected route. The value
in the type column is "connected".
Note: Routes pointing to local machines are labeled local, with a single route
for each local IP address.
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
Removes the default route
Removes all static routes and RIP entries
Identifies the particular routing entry
Name of the interface through which a packet addressed to
this destination will be sent.
The address of the gateway to use for that destination
network.
Display all routes in the routing table.
netmask gateway
* 0.0.0.0
255.255.255.0 168.126.188.100
255.255.255.0 168.126.188.130
met ifname type
1 wan static
1 lan static
0 lan connected
23