Net to Net Technologies SIA2410R User Manual page 35

Setting up Routing-Only Mode
This mode becomes set as a default mode when setting the IP
address in the interface. This mode provides the routing services for
the IP packets. The following command is for manually setting or
deleting the routing mode.
Command
Parameters
Setting up Routing and Bridging Mode
The following command is available for enabling or disabling the
bridge mode in the specified interface. Setting the bridge mode
without deleting the routing mode will trigger a setup of "Routing and
Bridging Mode".
Command
Parameters
Confirmation of
Setup
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
ip routing enable <ifname>
ip routing disable <ifname>
<ifname> - Interface name
interface <ifname> bridge enable
interface <ifname> bridge disable
<ifname> Interface name
enable enabling the bridge mode
disable disabling the bridge mode
(conf)# sh int
: Confirm "Routing and Bridging Mode".
34