Configuring Dhcp Function - Net to Net Technologies SIA2410R User Manual

Configuring DHCP Function

The DHCP (Dynamic Host Configuration Protocol) protocol enables a DHCP
client who has not set the IP address to receive an IP address, and other host
configuration parameters, automatically.
Net To Net Technologies SIA2410R supports the following two functions: a
DHCP relay function that delivers the IP address request packet received from
the DHCP client to the specified DHCP server, and a DHCP server function that
allocates the IP address upon the receipt of the IP address request packet.
With these functions, the DHCP client can gain access to the IP network
without setting the IP address.
Setting DHCP relay service
To set up dhcp relay, you have to set the following command:
Command
Parameters
Example
To delete dhcp relay, you have to set the following command:
Command
Setting up a DHCP Server
Step1: Setting the IP address pool :
To assign IP addresses dynamically, set the IP address pool. It is
possible to set up multiple pools, but the range of IP addresses must
not overlap. The following command configures an IP address pool:
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
dhcp relay to <server>
dhcp relay off
<server > IP address of DHCP server
(conf)# dhcp relay to 168.126.63.1
dhcp relay off
36