Net to Net Technologies SIA2410R User Manual page 48

How to Configure VLANs and Priorities per Port
The Port names are pre-defined; p1, p2, p3, p4, up (uplink; to the CPU). Let's
assume a sample network as follows; an IP phone that needs high priority
(priority 7) service is connected to port 1, and all the traffic from the IP phone
goes through the uplink port only. This means that the two ports (port 1 and
uplink port) must be in the same VLAN. Two PCs are connected to ports 2 and
3. They want to share files on their computers and connect to the internet. In
this case, port 2, port 3 and the uplink port should be in the same VLAN.
IP Phone
PC
PC
SIA2410R(conf)# sh vlan
port p1 p2 p3 p4 up vid pri tag-action
---------------------------------------------------------------------
p1 v v v v
p2 v v v v
p3 v v v v
p4 v v v v
up v v v v
By default, all ports are in the same VLAN and the tag action is "pass-
through" mode.
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
SIA2410R
p1
pri(7)
p2
pri(7)
pri(2)
p3
pri(2)
v 0 0 pass
v 0 0 pass
v 0 0 pass
v 0 0 pass
v 0 0 pass
up
47
to DSLAM