Accessing The Console - Net to Net Technologies SIA2410R User Manual

Accessing the Console

Connecting via the Console Port
To configure the router a serial connection needs to be made between the
SIA2410R and a PC. Connect the RJ-45 connector to the port labeled
'CONSOLE' on the back of the SIA2410R unit, and the other end of the cable
(DB-9 connector) to the computer's COM port.
Run any communications
(HyperTerminal or Zterm for example) to communicate directly with the
router through the computer's COM port.
Note: If random or illegible characters appear on your display, the
communications settings are probably incorrect. Mask sure that your
communications software is configured as follows.
[Table 2-2] Console software parameters
PARAMETER
Bits per Second
Data Bits
Parity
Stop Bit
Flow Control
Terminal Type
Telnet Connection
Once the SIA2410R has been configured with an IP address, you may use the
IP address to open a Telnet session with the unit from any workstation on the
same network. The Net To Net Technologies SIA2410R can be configured
using a program that supports the Telnet protocol.
Net To Net Technologies
Net To Net Technologies SIA2410R User Manual
program that supports
VALUE
9600
8
N
1
None
VT100
vt100 emulation
13