Replacing The Product With A Replacement Device - SMA SUNNY TRIPOWER CORE2 Operating Manual

SMA Solar Technology AG

14 Replacing the Product with a Replacement Device

Under fault conditions, the product may need to be replaced. If this is the case, you will receive a
replacement device from SMA Solar Technology AG. If you received a replacement device,
replace the defective product with the replacement device as described below.
Procedure:
1. Decommission the defective product (see Section 13, page 96).
2. Mount the replacement device (see Section 6, page 25) and make the electrical connections
(see Section 8, page 34).
3. Commission the replacement device (see Section 9, page 52).
4. Establish a connection to the user interface of the inverter (see Section 10.1, page 55).
5. Configure the country data set (see Section 10.9, page 62).
6. If the defective product had been registered in a System Manager, replace it with the new
product in the System Manager (see manual for System Manager).
7. Pack the defective product in the packaging of the replacement device and arrange with SMA
Solar Technology AG for it to be picked up.
Operating manual
14 Replacing the Product with a Replacement Device
STP110-60-BE-en-16 99