Skyjack SJIII 4620 Operating Manual page 51

Dc electric scissors
Hide thumbs Also See for SJIII 4620:
Table of Contents

Advertisement

Section 3 - Operation
9.
Remove remaining pins from all sides and
carefully fold all guardrails in the following order:
SJIII 32xx
Entrance
Use tie wrap to secure entrance bar to left
guardrail.
Right Side
Left Side
Extension
Lock extension guardrail into place on the
mounting post. Ensure that the detent ball of the
pin is all the way through.
SJIII 46xx
Right Side
Left Side
Entrance
Extension
Lock extension guardrail into place on the
mounting post. Ensure that the detent ball of the
pin is all the way through.
Locking
Pin
Figure 3-13c. All Guardrails Folded Down
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
SJIII DC Electric
(Refer to Figure 3-13c)
(Refer to Figure 3-13c)
WARNING
To raise the guardrail system up:
1.
Ensure aerial platform is on level ground.
2.
Ensure extension platform is fully retracted.
3.
Ensure Emergency Stop button is depressed.
4.
Turn main power disconnect switch to "
position.
Any lowered guardrail will create a fall
hazard. Use caution when exiting or
entering the platform when the guardrails
are lowered.
The scissor assembly must be fully
lowered before raising or lowering the
guardrails.
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
5.
Use the ladder of aerial platform to access
platform.
6.
Remove locking pin from mounting post and
carefully raise extension guardrail up and lock into
place with locking pins ensuring that the detent
ball of each pin is all the way through
Figure 3-13c).
7.
Carefully raise each guardrail up and lock into
place with locking pins ensuring that the detent
ball of each pin is all the way through
Figure 3-13a).
8.
Mount the platform control console at the front
right of the platform. Lock it in place.
Before operating this aerial platform,
check the guardrail system for loose
or missing locking pins. The guardrail
system must be upright and all pins must
be locked in place. Death or serious injury
could result if the guardrail system is not
upright or properly locked.
Guardrail Folding Procedure
WARNING
WARNING
WARNING
(Refer to
(Refer to
WARNING
Page 51
" off

Advertisement

Table of Contents
loading

Table of Contents