Skyjack SJIII 4620 Operating Manual page 17

Section 2 - Familiarization
2.2-7 Platform Control Console
This removable control console is mounted at the right
front of the platform. It contains the following controls:
1
5
6
Figure 2-6. Platform Control Console
1. Lift/Drive/Steer Enable Trigger Switch - This
momentary " " switch energizes the controller.
It must be held depressed continuously while
engaging either the lift/drive or steer functions.
2. Lift/Drive/Steer Controller - This one-hand lever
controls lift/drive and steer motions. Internal
springs return it to neutral when controller is
released.
3. Emergency Stop Button/Operation Light - This
button " ", when depressed, disconnects
power to the control circuit. The operation light
indicates upper control availability. It glows when
both emergency stop buttons on the platform
control console and the base control console
are pulled out.
SJIII DC Electric
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
2
3
4
contained in this operating manual and on the aerial platform.
4. Horn Push Button - This "
sounds an automotive-type horn.
5. Inclined Drive/Level Drive Switch - This switch
selects " " inclined drive (low speed/high
torque) or " " level drive (high speed/low
torque).
NOTE
Inclined drive (low speed/high torque) is
not available on 3215 and 3219 models.
6. Lift/Off/Drive Switch - Selecting "
disconnects power from both lift and drive circuits.
Selecting " " lift position energizes the lift circuit.
Selecting " " drive position energizes the drive
circuit.
WARNING
Skyjack scissor lifts are to be operated
from the operator's position on the
platform with the control box secured on
the mounting bracket at the front right
portion of the platform. Operation of the
unit from the ground is permissible only
when maintaining the lift or, in limited
circumstances, when an obstruction
precludes the safe operation of the
lift from the operator's position on the
platform. Operation from the ground is to
be performed as set forth in the Operating
Manual.
Control Functions
" push button
" off position
Page 17