Skyjack SJIII 4620 Operating Manual page 30

Function Tests
Platform Control Console
Lift/Drive/Steer Enable
Trigger Switch
Inclined Drive/Level Drive
Switch
• Test Platform Raising/Lowering
Be aware of overhead obstructions
or other possible hazards around the
aerial platform when lifting.
1. Select lift/off/drive switch to "
position.
2. Activate and hold "
switch.
3. Push controller handle and raise the
platform to an approximate height of 1 ft.
(30.5 cm).
Result: Platform should rise.
4. Pull controller handle and lower the
platform fully.
Result: Platform should lower.
Page 30
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
Lift/Off/Drive Switch
WARNING
" lift
" enable trigger
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
Rocker Switch
Controller
Emergency Stop Button/
Operation Light
Horn Pushbutton
• Test Horn
1. Push " " horn push button.
Result: Horn should sound.
• Test Pothole Sensor
WARNING
Ensure that you maintain three points
of contact to mount/dismount platform.
1. Use the ladder to dismount from platform
and place a block, approximately 1.5"
(3.75 cm), under the hydraulic/electric
tray.
2. Use the ladder of aerial platform to access
platform.
3. Close the gate.
4. Raise the platform until approximately a
height of 7 feet (2 meters) is reached and
attempt to drive forward or reverse.
Result: Aerial platform should not move
forward or backward.
SJIII DC Electric