Advertisement
4.
LINKING TO THE AnACPU (WITH DEDICATED INSTRUCTIONS)
AND THE AJ71 PT32-S3
MELSEC-A
4.6.1
initial setting of an AJ71 PT32-S3
Use the SW[ ]GP-MINIP system disk to set the initial data and to store it in
the initial data ROM.
Total number of remote stations:
Set the total number of occupied stations of each module connected to the
AJ71 PT32-S3.
I
i
AY51C (remote
1/0 module)
: 4 stations
J
Remote terminal data setting
(1) Number of remote terminal modules
(2) Head station number of each remote terminal module
(3) Attribute (protocol)
"MINI standard protocol" is used.
(4) Determines how the FROM and TO areas will share the 1000 words
allocated to FROM and TO addresses.
*
The default value of each area is set to
500
words.
Install the initial data
ROM into the "socket
for initial data ROM" of the
AJ71 PT32-S3.
Set the mode switchover pin to "48 (EXTENSION mode)".
The SW[ ]GP-MINIP Operating Manual gives details about setting proce-
dures.
4-25
Advertisement
