Using Led+/- To Activate A Led Lighting Device - Matrox Breakout Box Installation And Technical Reference

Using LED+/- to activate a LED lighting device

You can route the controlled-current output from your Matrox camera to a LED
lighting device through your Matrox Breakout Box module. To do so, perform
the following:
1. Connect the digital I/O and power cable of your Matrox camera to your Matrox
Breakout Box module by following the steps in the Powering and connecting your
Matrox camera section, earlier in this chapter.
2. Connect an open-wire cable from the positive wire-terminal (+) of the LED
lighting device to the LED+ wire-terminal of the Matrox Breakout Box.
3. Connect an open-wire cable from the negative wire-terminal (-) of the LED
lighting device to the LED- wire-terminal of the Matrox Breakout Box.
Using LED+/- to activate a LED lighting device
24V
Aux4
Aux5
Aux6
Aux7
LED+
CCS
output
LED-
GND
Matrox Breakout Box
Direct output connector
+
LED
lighting
device
-
31