Table of Contents
Advertisement
Connect your instrument and amp
The P2 can be wired like any other effect pedal.
Connect your guitar to the INPUT (1) of the P2 with an instrument cable; use another instrument
cable to connect the OUTPUT (2) to your Amp or other effects.
You can put other effects before or after the P2. You may have to adjust the input gain of the P2
using the Prime App if you use high-gain pedals in front of the P2. See section Input Gain below.
Power on
Long press the Power button (8) for two seconds to activate the pedal. After a few seconds of
powering up, the screen will show the currently selected preset number and bank as well as the
name of the active preset.
Preset selection on the P2 touch screen
Tap on one of the letters A, B, C or D to select one of four presets in the
currently selected bank. The active preset is indicated by a filled circle around
the letter and by the name in the middle of the screen.
Bank selection on the P2 touch screen
Tap the preset name in the middle of the screen to open the bank selection
mode and tap on the right / left arrows to select one of 20 banks.
After selecting a bank, you need to tap one of the four preset letters, to
actually activate the preset within the selected bank. If you do not select a
preset within 3 seconds, the screen will switch back to the currently active
preset.
P2 Tools screen
Swipe down on the touch screen to access the Tools screen.
Tap the tuning fork to tune your guitar. Depending on a setting
controlled by the PRIME App, the output may be muted for silent
tuning. See section Tuner.
Tap the speaker icon to open an output volume control bar.
Tap the footswitch icon to connect / disconnect a wireless footswitch
(footswitch must be in pairing mode to connect).
Tap the Bluetooth icon to activate / deactivate the Bluetooth audio
playback feature.
The battery indicator shows the status of the P2 battery.
INSTRUCTIONS
5
Advertisement
Table of Contents
