Tap Tempo; Tuner; Drummer & Looper Control; Opening / Closing Drummer & Looper Mode - Mooer PRIME P2 Owner's Manual

Tap Tempo

 If a Delay effect is active for the currently selected preset, you can tap the footswitch for the
active preset once to activate the Tap-Tempo mode and control the delay time.
NOTE: The Tap-Tempo mode is indicated by a dots being shown behind the letters and numbers in
the footswitch screen (e.g. "3.C."). You can adjust the tap tempo while the dots are shown. The tap
tempo mode will be deactivated after 2.5 seconds without input, the dots disappear and the
footswitch returns to preset switching mode.
Tap the footswitch repeatedly in the desired tempo to directly adjust the delay time. The tap

tempo may not exceed the max/min delay time for the selected effect.
The footswitch LED will blink briefly to indicate the tapped tempo.


Tuner

 Long press any footswitch to enter the TUNER mode.
NOTE: The PRIME App (if active and connected) will also enter the TUNER Mode, but you can use the
footswitch for tuning without the app.
If the screen on the P2 unit is not in "locked" mode, it will also show the tuner mode while tuning is
activated on the footswitch.
 The left block of the footswitch screen shows the nearest note, while the right block indicates
the pitch. Semi-notes are indicated by # (e.g. "A
 The right block does not move if the string is in tune, it will rotate counterclockwise if the
note is flat or clockwise if the note is sharp.
Tap any footswitch button once to exit the tuning mode and return to preset switching mode.

NOTE: Users can turn on/off silent tuning in the PRIME App.
Drummer & Looper Control
The P2 is equipped with a built-in 80-second Looper with storage slots for up to 10 songs
and a Drum Machine with 56 grooves + 4 metronomes (grooves 57-60).
The Looper and the drum machine can work simultaneously.
Opening / closing Drummer & Looper mode
 In preset switching mode, press switches B and C simultaneously to enter the
Drummer & Looper mode.
The footswitch screen will show the blinking number of the currently selected Song slot for
the Looper (e.g. "S1".)
Press switches B and C simultaneously again to return to the preset mode.


Controlling the Looper

In Drummer & Looper mode, footswitches A and B are used for Looper control:
A: REC/PLAY/DUB

Tapping A will start the recording, tapping A again will play the recorded track, tapping A yet
again will start an overdub recording over the first track layer and so on ...
The A LED blinks during Record/Overdub and is continuously lit during Playback.
0")
。
18