Setting; Cabsim; Global Eq; Input Gain - Mooer PRIME P2 Owner's Manual

Setting

Cabsim

This switch can be used to turn off all cabinet simulations with one click if you
use third party speaker cabinets or simulations.
With Cabsim ON, you can set up a Cab module in any preset effect chain and
save it's on/off status.
Cabism OFF deactivates all Cab modules in all presets.
You can then manually activate a Cab module in a preset, but cabinet
simulation will be turned off again, as soon as you switch to another preset.

Global EQ

Use this to activate and adjust global EQ settings that will be applied to the output signal,
independent of any preset settings.

Input Gain

This setting adjusts the input gain for the P2.
Use it, to attenuate clipping if you are using pre-amplifying effects or an instrument with active
electronics in front of the P2.

MIDI Settings

Use this section to assign MIDI CC commands received from an external
controller to P2 functions for Preset Control, Drum Machine Control or
Looper Control.
Connect a MIDI Controller, send the desired CC command and use the
"Learning" button to assign the command to a function.
You can also remove MIDI command assignments in this section.

Version

This field shows the current version of the P2 firmware.

Reset

This will reset your P2 and the App to factory settings!

Please back up your presets to the cloud or your PC to prevent them from being deleted.

You can later restore them from the cloud via MOOER Studio PC Software.
All recorded loops will be deleted.

 Use the MOOER Studio software to backup your settings before performing a reset or update.

Display brightness

This setting controls the brightness of the touch screen display on the P2. Adjust the brightness to
the lighting conditions at the venue.
13