Saving A Preset; Library Page; Mixer Page - Mooer PRIME P2 Owner's Manual

Saving a preset

 Tap the "SAVE" button behind the preset name to re-name and save
the preset. You will be prompted to specify a name and a storage
location.
 Edit the name to your liking. If you upload your preset to the cloud, it
will be published under this name.
Specify a storage slot.

The P2 provides 20 preset banks (0 through 19) with 4 slots each (A through D).
NOTE: The number (0 - 19) designates the bank number and the letter (A - D) determines the
position of the preset within the bank.
NOTE: Saving a preset in a slot will overwrite any preset that is currently stored in this slot.
Tap SAVE to save the preset or CANCEL to discard your changes.


Library Page

This page shows a list of pre-configured sounds you can use as a basis for your
own creations. The samples are grouped by style for easier identification.
Select a sound, play your instrument and listen to the effects. If you like what
you hear, use the "SAVE" button to store the sound in a preset slot and then
adjust it to your liking on the Effect page.
NOTE: Saving a preset in a slot will overwrite any preset currently stored in
this slot.

Mixer Page

This page shows a mixer with faders to adjust the output levels for different
sources (Vocal, Bluetooth, USB, Instrument). Each channel can be individually
muted using the
The Vocal channel controls the input from a headset microphone connected
to the 3.5 mm TRRS headphone jack. The microphone signal is mixed in with
the output signal. This channel is also equipped with an "EFX" button to
access compressor, EQ and reverb effects that will only be applied to the
microphone signal.
The USB Fader controls the output signal over USB OTG (not the incoming USB signal).
Swipe left to access Master volume faders. Use the Mono / Stereo buttons to
select the output mode and the individual faders to control the Stereo
panorama.
mutes the complete output.
links the L and R faders.
buttons.
11