Wireless Footswitch; Pairing; Preset Switching - Mooer PRIME P2 Owner's Manual

Intelligent pedal

Hide thumbs

Table Of Contents

Table of Contents

The Prime P2 supports MOOER F4 wireless footswitches (to be

purchased separately). The footswitch allows users to control Preset

Switching, Drum Machine, Looper and Tuner and it provides a Tap

Tempo function.

Please consult the manual for the F4 footswitch for battery specs

and charging requirements.

The P2 can only be connected to one wireless footswitch at a time.

Pairing



The footswitch must be paired with the P2 before you can use it for the first time.



For pairing you can use the Prime App or the touch screen on the P2.

Power the F4 footswitch on, press and hold footswitch A and C to enter pairing mode.



The footswitch LEDs will start to blink.



Tap the footswitch icon

Alternatively you can swipe down on the P2 touch screen and tap on the footswitch icon in

the Tools screen.

After pairing is complete, the screen on the F4 footswitch will show the currently selected



preset number and the LED stop blinking.

The footswitch icons in the app and on the P2 Tools screen will be shown in blue to indicate

successful pairing.

NOTE: The footswitch only needs to be paired once (or after a reset) and will then automatically

connect as soon as P2 and F4 footswitch are turned on and within range of each other.

After the initial pairing, the footswitch can be used to control the P2 even without the Prime App

being active or connected.

Preset Switching

The Footswitch will always indicate the selected preset, regardless of whether it was selected using

the touch screen on the P2, the preset selection list in the Prime App or the A/B/C/D buttons on the

footswitch.



Press the A/B/C/D buttons to switch between four preset patches in the current bank.

The active preset will be indicated by the respective LED above the footswitch and in the footswitch

screen: the number indicates the bank and the letter indicates the preset within the bank (e.g. "3d").

For better readability, A and C are represented as capital letters; b and d as lower case letters.

Banks 10 through 19 are represented by a dot behind the number

(e.g. "0.d" = 10D or "9.A" = 19A)

Bank Switching

Press switches A and B simultaneously to scroll up through the preset banks.



Press switches C and D simultaneously to scroll down through the preset banks.



Once a bank is selected, the preset indication in the footswitch screen starts blinking, but the

preset is not yet active. You need to tap one of the four footswitch buttons, to select a preset

within the selected bank. Only then will the selected preset be activated and the footswitch

indication stops blinking.