Layout - Mooer PRIME P2 Owner's Manual

1. Input jack: 6.35 mm (1/4") TS jack. Connect your instrument cable from your guitar here.
2. Output jack: 6.35 mm (1/4") TRS jack. Use an instrument cable to connect to your amplifier. You
can use a TRS  2 x TS splitter adapter to achieve stereo output.
3. HEADPHONE: 3.5 mm (1/8") TRRS jack for headphone / headset connection. If used with a
headset (headphones + microphone), the microphone input can be mixed in with the output
signal.
4. Control interface touch screen: Shows the currently selected preset. Swipe to display volume
controller, tuner, battery status, Bluetooth status and footswitch connection. When the P2 is
turned off and connected to a power supply, the screen shows the battery charging status in
percent.
5. LED indicator strip: The indicator strip flashes in different colors during boot-up and then lights
up each time an input signal is detected.
6. MIDI jack: 3.5 mm (1/8") jack for connection to a MIDI controller.
7. USB-C charging port / OTG port: Use the supplied USB-C to USB-A cable to connect to a regular
5 V, 2.0 A USB-A power supply unit (e.g. mobile phone charger). Connect this port to a computer
or mobile device (OTG adapter required) to play back or record audio
8. Power button: Long press for Power ON/OFF; short press to lock/unlock the touch screen.
9. Reset Switch: Should the P2 fail to react and this cannot be remedied by switching the unit off
and on again with the Power button, you can use a paper-clip or a pin to press the reset button in
this hole. This will force the device to turn off. It can then be re-started with the Power button.

LAYOUT

3