Operation Modes; Live Mode; Preset Mode - Mooer Red Truck Owner's Manual

Redtruck has two different operation modes. LIVE MODE and PRESET MODE
To change operation mode, simultaneously press and release TAP + Footswitch 1
In this mode Redtruck operates like a traditional pedalboard. Each footswitch will
switch it's respective effects module on and off.
The DISPLAY SCREEN will display <L> when in Live Mode
In this mode Redtruck operates like a pedalboard loop switcher. Each footswitch
will recall a preset combination of which effect modules are on/off.
The DISPLAY SCREEN will display <P> when in Preset Mode
To create a preset:
1.Ensure Redtruck is in LIVE MODE
2.Activate the effect modules you want to use in your preset
3.Press and hold the corresponding footswitch where you wish to save the preset
for use in Preset mode
4.The Footswitch light will flash 5 times to confirm that the preset has been saved
to this footswitch
5.After you have saved your presets, put the Redtruck into PRESET MODE and
press any footswitch from 1-5 to recall it's preset.
Note: Effect parameters can not be stored to the presets. Only the on/off state of each effect module will be stored.

Operation Modes

Live Mode

Preset Mode