PureTools PT-IP-HD26X User Manual page 25

User Manual
PT-IP-HD26X
Transmission Protocol: You can select "udp unicast" or "udp multicast" (udp multicast
by default).
Scaler Setting: You can set the output resolution (Pass Through by default).
Download EDID: You can download the EDID binary file of the display device connected
to the Decoder. The EDID file can be used as the User EDID file to be uploaded to the
Encoder.
NoSignal:
VideoOut:
ON: Turn on video out when there is no signal.
OFF: Turn off video out when there is no signal.
OSD Information:
ON: Display OSD information when there is no signal.
OFF: No display OSD information when there is no signal.
Video Timeout Setting: You can set the timeout to turn off the video output when no
input video signal is detected. 0 means never close.
ID Setting:
Local ID: You can set the ID of the Decoder. (After setting the ID, the IP will change. You
need to press and hold the (CH SELECT) UP button on the front panel of the Decoder for
5 seconds to check the IP address, and then re-enter the new IP address on the web
page to continue setting).
Max Channel ID: You can set the maximum range of Source Selection ID that can be set.
When it is set to 0, there is no limit to the setting range of Source Selection ID.
Source Selection ID: You can select the ID of the Encoder to be the input source.
Picture Setting: You can configure the picture parameters (Brightness, Contrast, Hue
and Saturation).
■ Settings Page
On this page, you can set Network settings, modify username and Login Password as
required.
21