Encoder And Decoder Matching Settings; Web Gui User Guide - PureTools PT-IP-HD26X User Manual

User Manual
PT-IP-HD26X

8. Encoder and Decoder Matching Settings

When multiple Encoders and Decoders are in the system without a Controller Box, it
is necessary to match them well firstly. You can match all Encoders and Decoders in
following two methods.
Method 1: Use the CH SELECT buttons on the front panel of the Encoder/Decoder.
According to the methods mentioned in Chapter 5, set the ID of Encoder, then set the
ID of Decoder, finally set the Encoder ID from which to subscribe the stream. Match
all Encoders and Decoders in the same way.
Method 2: Use the RS-232 serial port command control.
Connect the RS-232 port of Encoder/Decoder to a PC or control system, using the
PureLink PTM-RS100 adjustable RS232 cable or any other suitable cable. Then use a
Serial Command tool on PC to send the RS-232 command code: "!OUT xxx FR yyy\r\n".
The function of this command is to connect the Decoder (ID:xxx) to the Encoder (ID:
yyy). Match all Encoders and Decoders in the same way.

9. Web GUI User Guide

You can use the built-in Web GUI to configure all products through a Switch.
The operation method is shown as below.
Step 1: Match all Encoders and Decoders as described in Chapter 7.
Step 2: Connect the PC and IP products you need to configure to a Switch.
The connection diagram is shown as below.
15