Rotax 912 i Series Service Instruction page 14

SI-912 i-029 / SI-915 i-012
SI-916 i-007
Step
1 Allen screw M6x14
2 Lock washer A6
3 Cable clamp 12/M6
Step
1 EGT sensor cable
2 Double ignition coil cable
3 Cable tie
08 February 2024
Initial Issue
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
9 Secure the cable clamp 12/M6 with an Allen screw M6x14 and lock washer with
LOCTITE 243. Tightening torque 10 Nm (89 in. lb).
10 Install the cable tie on the exhaust gas temperature sensor cable (Cyl. 1_3) connected
with the double ignition coil cable.
SERVICE INSTRUCTION
Procedure
Fig. 12
Procedure
Fig. 13
74-20-00
Page 14 of 15