Table of Contents
Advertisement
installation
|
10
FACEPLATE AND TRIM INSTALLATION
Your Faceplate kit contains:
1
Set Faceplate panel (top, left & right)
1
Set Trim (top, left, right)
2
pcs. insulation
4
spring nuts
4
1" screws
8
washers
2
screws - black
2
corner trim clips
Note: The Digital Monitor Operating Door tool Bracket
and tool holder are supplied with the insert.
Prior to sliding your insert into its fi nal position and
attaching the connector or liner pipe, the faceplate must
be installed as follows:
1) Slide the spring nuts (supplied) over the slots in
the insert's side convection panels (the spring nuts
may need to be squeezed with a pair of pliers fi rst,
to help them stay in position).
2) Screw the side faceplate panels, (item A in the
diagram) one to each side. See diagram 1.
Diagram 1
920-057
10 |
Regency I2500-1 Wood Fireplace Insert
WOOD INSERT
Wood Insert
Faceplate & Trim Assembly
3) Slide the digital monitor operating tool bracket lining
up the slots on the bracket to the 2 loose screws
on item A on left hand side Once slid into position
tighten screws on both left and right side (item A)
See diagram 2.
Digital monitor operating
door tool bracket
Screws securing both
surround and bracket
on left hand side
when facing the
appliance from front
Diagram 2
4) Using the top panel (item B - see diagram 1) as a
gauge, check that the side panels are within ap-
proximately 1/4" of the overall width. If the difference
is greater than this, use the supplied washers to
attain the required width.
5) The unit may now be slid into fi nal position and
attached to the connection system.
6) Once connection is made, the insulation strips
should be installed between the insert faceplates
and the fi replace face.
7) The faceplate top may now be installed (with insula-
tion strip behind) by aligning its brackets with the
top fl ange on the side shields and the angle iron
bar on the insert top.
8) The faceplate trim may be installed to the edge of
the faceplate at this time. To permanently mount the
trim, drill two 5/32" diameter holes through the trim
and side panels and screw the trim to the panels
using the gold plated screws provided.
1
I2500M
Tool holder slid into tool bracket
Tool Holder
Slots in door tool
bracket
02.07.19
Advertisement
Table of Contents
