Table of Contents
Advertisement
WOOD DOOR & HANDLE ASSEMBLY
WOOD DOOR & HANDLE ASSEMBLY
1.
In preparation of installing the door handle, the nuts,
cam, washers and spacer must be removed as shown in
Diagram 1.
Nuts
Cam
LATCH ADJUSTMENT
The door latch may require adjustment as the door gasket
material compresses over time. Removal of 1 or 2 wash-
ers will allow the latch to move closer to the door frame,
causing a tighter seal. (Refer to Diagram 1)
919-967
WOOD STOVES & INSERTS
Spacer
Washers
Diagram 1
2.
Place the door onto the hinges and then place the door
handle through the opening on the door, as shown in
Diagram 2.
Re-assemble and secure the door handle components in
reverse order as removed in step 1, refer to Diagram 1.
3.
Put the hinge cover caps on top of hinges to complete the
door installation.
Note: The bottom of the door may scrape the ashlip. In this
case place the spacers provided on the door hinges of
the unit before placing the door.
Door
Handle
4.
Close door and ensure there is a tight seal. If door is too
tight a washer can be removed. Recheck door to ensure
there is still a tight seal. The handle should be approxi-
tooltip
mately in the 8 o'clock position when door is fully closed.
(Diagram 3)
Wood handle
Door handle
tooltip
installation
Door
Hinge Cap
Cover
Diagram 2
Diagram 3
Regency I2500-1 Wood Fireplace Insert
|
17
Door hinges
|
17
01.25.19
Advertisement
Table of Contents
