Setting The Lawnmower Operation; Mowing Setup - Honda Miimo HRM1000 Owner's Manual

Setting the lawnmower operation

Setting the lawnmower operation

Mowing setup

You can set up the Mowing settings as follows:
NOTE:
- Shortcut wire is not available on the HRM1000.
Setting the angle to turn from the boundary wire or the shortcut wire
When leaving the boundary wire, set the angle to turn
from the boundary wire.
L Angle settings in [1.Start points] (M page 55)
- Set the angle of departure for when the lawnmower
arrives at the position specified by the angle of [1.Start
points].
Setting the overlap
distance on the
boundary wire
Set the distance that the
lawnmower can cross the
boundary wire.
L [1.Wire Overlap]
(M page 57)
NOTE:
- To have the lawnmower
smoothly turn from
the boundary wire, the
recommended value of
the Wire overlap is 20 cm.
Setting the operation ratio of each area operation
Set an area operation ratio if you want to mow more
frequently from a certain start point.
For example, if you set the ratio for "Point 1" to 30%,
the lawnmower will start mowing 3 times out of 10
from "Point 1" and 7 times out of 10 from other start
points.
L Percentage settings in [1.Start points] (M page 55)
NOTE:
- You can configure 3 start points (HRM1000,
HRM1500, HRM1500 Live) or 5 start points
(HRM2500, HRM2500 Live).
NOTE:
- If you want to operate the lawnmower with the Auto mode, see "Operating the lawnmower in the Auto mode."
(M page 89)
52
Point 1
Point 2
Shortcut wire 1
Example: 5 start
points(HRM2500,
HRM2500 Live)
Setting the distance to the start point
Until the lawnmower reaches a set starting point
in an area, it will run without mowing.
L Distance settings in [1.Start points]
(M page 55)
- Sets the distance from the docking station to
start cutting.
Boundary wire
Point 4
Point 3
Point 5
Installing and setting the shortcut wire
Install the shortcut wire if you want to shorten the
time to reach the mowing start point and return to the
charging station. The lawnmower traces the shortcut
wire and suppresses the occurrence of wheel tracks.
Setting the starting
direction from the
docking station
Set whether the
lawnmower should
travel clockwise or
anti-clockwise along
the boundary wire to
reach a set starting
point. If the shortcut
wire is installed, the
shortcut wire can be
selected in addition to
the boundary wire.
L S1(Shortcut wire 1),
(Clockwise) or
(Anti-clockwise) in
[1.Start points]
(M page 55)