Honda Miimo HRM1000 Owner's Manual page 38

3.
Testing the start points
Through this testing, you can check the start points which you added in [2.Start points].
NOTE:
- Perform each test when the lawnmower is connected to the docking station.
Select [3.Test start points] and press the
1
3-
button to check the start points.
Select a start point number and press the H button.
2
3-
The information of the selected start point is displayed.
If you do not test, select [OK] and press the H button.
Go to step 4-1.
Confirm the setting information of the selected start
3
3-
points.
NOTE:
- Passage width is the distance between the
lawnmower and the boundary wire or shortcut
wire when following it. For example, running line
0 is 10 cm, 5 is 50 cm. For details, see "Boundary
wire passage width sample table" (M page 53).
Close the control panel cover.
4
3-
The lawnmower starts towards the selected start point.
When the test is correctly finished, the lawnmower
rolls slowly and a beep sound is emitted from the
lawnmower.
Press the manual STOP button.
5
3-
The control panel cover pops up.
Setup wizard
H
1. Garden lay ou t
2. Start points
3. Tes t s tart points
4. Work timer
Test start points
Point S1 /
1 /
2 /
3 /
4 /
5 /
0Home
Test start points
Point 1
Locat ion
Pas s age widt h
Clos e c over to st art
Setting up the lawnmower
3/4
3/4
/
/ 50m
/ 50m
m
/
m
/
m
/
NEXT
3/4
CW 0m
10
35