Manual Mode Crossfade; Manual Mode Hold Time; Clear Manual Mode Step; Disable Manual Mode Step - Chauvet DJ INTIMIDATOR BEAM 360X User Manual

Manual Mode Crossfade

To set how long the product will take to fade between steps 1 and 2 and back, follow the instructions below:
1. Set the product to manual mode.
2. Use <UP> or <DOWN> to select Crossfade (sec).
3. Press <ENTER>.
4. Use <UP> or <DOWN> to increase or decrease the amount of time (in seconds), from 0000–1200.
5. Press <ENTER>.
While fading, all functions will go through each value between the two values set in either
step. To prevent this, set Crossfade (sec) to 0000.

Manual Mode Hold Time

To set how long the product will hold each step before switching to the other step, do the following:
1. Set the product to manual mode.
2. Use <UP> or <DOWN> to select Hold time (sec).
3. Press <ENTER>.
4. Use <UP> or <DOWN> to increase or decrease the amount of time (in seconds), from 0001–1200.
5. Press <ENTER>.

Clear Manual Mode Step

To set all values for a step to 000, follow the instructions below:
1. Set the product to manual mode.
2. Use <UP> or <DOWN> to select from Step 1, or Step 2.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Clear.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select NO (do not clear) or ON (clear the selected step).
7. Press <ENTER>.

Disable Manual Mode Step

To set all values for a step to 000 and disable it from playback, do the following:
1. Set the product to manual mode.
2. Use <UP> or <DOWN> to select from Step 1, or Step 2.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Delete.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select NO (do not delete and disable) or ON (delete and disable the
selected step).
7. Press <ENTER>.
To enable a disabled step, program any value in that step by following the instructions
under Program Manual Mode

Program Manual Mode Step

To program one of the steps of manual mode, follow the instructions below:
1. Set the product to manual mode.
2. Use <UP> or <DOWN> to select from Step 1, or Step 2.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select from Pan, Tilt, Color, Gobo, Prism, Focus, Frost, Dimmer, or
Shutter.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to increase or decrease the value of the selected function, from 000–255
(functions work the same as in DMX mode).
7. Press <ENTER>.
8. Repeat steps 4–7 until the selected step is set as desired.
12
Step.
Intimidator Beam 360X User Manual Rev. 1
Operation