Safety Notes - Chauvet DJ INTIMIDATOR BEAM 360X User Manual

Safety Notes

These Safety Notes include important information about installation, use, and maintenance of the
Intimidator Beam 360X.
■ ALWAYS:
♦ Connect to a grounded circuit.
♦ Connect to operating voltages as specified on the product's spec sticker.
♦ Disconnect from power before replacing the fuse.
♦ Disconnect from its power source during periods of inactivity.
♦ Use a safety cable when suspending overhead.
♦ Heed all restrictions and warnings on the spec sticker.
♦ Mount in a location with at least 20 in (50 cm) of ventilation.
♦ Replace the fuse with the same type and rating.
♦ Use a clamp with a captive bolt when a single hanging bracket is used.
■ In the event of a serious operating problem, stop using immediately.
■ DO NOT:
♦ Open this product or attempt any repairs. It contains no user-serviceable parts.
♦ Look at the light source when the product is on.
♦ Use if the power cable is crimped or damaged.
♦ Disconnect by pulling on the power cable.
♦ Allow flammable materials close to the product when it is operating.
♦ Touch the housing when it is on.
♦ Block any ventilation holes/slots in the housing.
♦ Connect to a dimmer or rheostat.
♦ Carry the product by its power cable.
♦ Operate in temperatures higher than 104°F (40°C).
♦ Expose to environments that exceed the Ingress Protection (IP) rating.
♦ Expose to rain or moisture.
♦ Use outdoors.
♦ Submerge.
♦ Set this product on a flammable surface.
Keep this User Manual for future use. If the product is sold to someone else, be sure that
they also receive this document.
RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 cm between
the radiator and the user. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
2
Before You Begin
Intimidator Beam 360X User Manual Rev. 1