Table of Contents
Advertisement
Operation
Standalone Configuration
Set the product in one of the standalone modes to operate without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
Static Color
To run the Derby X with a static color, follow the instructions below.
1. Press <MENU> repeatedly until C--- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the desired color from C001–007.
4. Press <ENTER>.
Automatic Program
To run the Derby X with an automatic program, follow the instructions below.
1. Press <MENU> repeatedly until P--- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the desired program from P001–017.
4. Press <ENTER>.
Program Speed
To set the speed of the automatic program, do the following:
1. Press <MENU> repeatedly until S--- shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the program speed from S001–100.
4. Press <ENTER>.
Sound-Active Mode
To run the Derby X with a sound-active program, follow the instructions below.
1. Press <MENU> repeatedly until Snd shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the desired program from S 1–16.
4. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity of the product, do the following:
1. Press <MENU> repeatedly until SEnS shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from u001–100.
4. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
Derby X User Manual Rev. 1
8
Advertisement
Table of Contents
