Gobos; Standalone Configuration; Automatic Programs; Sound-Active Mode - Chauvet DJ INTIMIDATOR BEAM 360X User Manual

Operation

Gobos

Standalone Configuration

Set the product in one of the standalone modes to operate without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.

Automatic Programs

To run the Intimidator Beam 360X in automatic mode, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Auto.
5. Press <ENTER>.

Sound-Active Mode

To run the Intimidator Beam 360X in sound-active mode, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Sound.
5. Press <ENTER>.

Sound Sensitivity

To set the sound sensitivity of the product, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Sensitivity.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from 001–100.
7. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).

Manual Mode

To set the Intimidator Beam 360X to manual mode, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Manual.
5. Press <ENTER>.
Intimidator Beam 360X User Manual Rev. 1 11