Totem Mode; Dmx Loss; Indicator; Flash If Dmx - Chauvet DJ INTIMIDATOR BEAM 360X User Manual

Totem Mode

To activate the totem mode, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Totem Mode.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal range of motion), UP (upward tilt range), or DOWN
(downward tilt range).
7. Press <ENTER>.

DMX Loss

To set how the Intimidator Beam 360X will respond to losing a DMX signal, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select DMX Loss.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select Hold (continues the most recent setting), Black (blacks out the
product), Auto (switches to auto mode), or Sound (switches to sound-active mode).
7. Press <ENTER>.

Indicator

To enable or disable the LED indicator, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Indicator.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (disabled) or ON (enabled).
7. Press <ENTER>.

Flash if DMX

To set whether the LED indicator flashing indicates the presence or the absence of a DMX signal, do the
following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Flash if DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (flashing indicates no DMX signal) or ON (flashing indicates
a DMX signal is present).
7. Press <ENTER>.

RF Remote Bind

To bind an RFC or RFC-XL remote to the Intimidator Beam 360X, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select RF.
5. Press <ENTER> twice then follow the instructions on the display.

Reset

To reset all functions on the Intimidator Beam 360X, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Reset.
5. Press <ENTER>.
14 Intimidator Beam 360X User Manual Rev. 1
Operation