Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX signals
that could interfere with the DMX signals from the controller.
Automatic Programs
To run the Intimidator Beam Q60 in automatic mode, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Auto.
5. Press <ENTER>.
Sound-Active Mode
To run the Intimidator Beam Q60 in sound-active mode, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Sound.
5. Press <ENTER>.
Sound Sensitivity
To set the sound sensitivity on the Intimidator Beam Q60, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Sensitivity.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to increase or decrease the sound sensitivity, from 001–100.
7. Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
Manual Mode
To operate the Intimidator Beam Q60 manually through the menu, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Manual.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from Control, Pan, Pan Fine, Tilt, Tilt Fine, Continu.P,
Continu.T, Pan&Tilt Sp, Shutter, Dimmer, Color Fun, VirtualCol1, Red, Green, Blue, or White.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to increase or decrease the value of the selected function, from 000–255.
9. Press <ENTER>.
10. Repeat steps 6-9 until the product is set as desired.
Page 12 of 19
Intimidator Beam Q60 User Manual Rev. 1
Operation