Configuring Scep Renewal Request; Provisioning Of The Ca Certificate Through Scep - Konftel 800 Installation & Administration

SECURITY AND PROTECTION

Configuring SCEP renewal request

About this task
When Konftel 800 receives a device certificate from a SCEP server, the certificate
has a specified validity period, after which the certificate expires. Use this
procedure to configure a SCEP renewal request through the web interface.
Before you begin
Log in to the web interface as administrator.
Procedure
On the web interface, click
In the section, enter the value in
SCEP
.
Interval
The value range is from 1 to 99. The default value is 90.
Click .
Save
The phone reboots to apply the changes.
The web interface shows Save Succeeded pop-up message.
Related concepts
SCEP support on page 156

Provisioning of the CA certificate through SCEP

The SCEP server supports the provisioning of CA certificates, which Konftel 800
uses as the default CA certificates for all TLS connections.
If any of the TLS connections requires a specific CA certificate, you can do the
following:
• Install the certificate manually. Here, the phone uses the manually installed CA
certificate and ignores the certificate received from the SCEP server.
• Request and receive the certificate from the SCEP server.
If you have a CA certificate from the SCEP server and initiate the SCEP renew
enrollment process, the phone continues using this CA certificate after the SCEP
renew enrollment process ends.
Related concepts
Certificates on page 142
.
Provisioning
Initiate renewal on % of Validity
158