Provision Of The Ntp Server Address; Sleep Mode - Konftel 800 Installation & Administration

SETTINGS CONFIGURATION AND MANAGEMENT
• shows that the required information is currently unavailable. You
Unknown
must refresh the page and check it later.
Related information
Configuration parameters

Provision of the NTP server address

Use DHCP option 42 to provide NTP server address to Konftel 800 when using
802.1x certificates. In this case, you must have DHCP enabled on the phone to
display the accurate time received from this NTP server address.
When DHCP includes option 42 providing a valid NTP server address, Konftel 800
uses this value even if you configure the NTP server in the .xml configuration file.
When the DHCP option 42 does not provide an NTP server address, the value
from the configuration file becomes applicable.
Related concepts
DHCP configuration options
Related information
Configuration parameters

Sleep mode

Konftel 800 supports Sleep mode feature, which saves power by turning the
screen off after a specified period of inactivity. By default, Sleep mode is in
disabled state.
The phone administrator can enable Sleep mode and configure the time-out value.
The phone wakes up from Sleep mode when you do any of the following:
• Touch the screen
• Connect or disconnect the USB cable
• Connect or disconnect the Bluetooth
The phone also wakes up from Sleep mode during screen activity, such as an
incoming call, Konftel Unite connection, or error prompts.
The phone cannot enter Sleep mode during an active call or when it is in music
streaming mode.
You can configure Sleep mode only using the configuration file. The default value
is 0, which means that the feature is disabled. To enable Sleep mode and to
specify the time-out in minutes, set the value in the range from 1 to 500.
on page 35
on page 22
on page 35
® Classic
102